Your Leading Gratiot County, MI Waterproofing, Concrete Lifting & Leveling Experts

The best time to fix a problem is right when you notice it. That isn't always doable - life is busy and priorities change - but when it is, you reap the benefits not only in lower costs, but also less time spent worrying.

Alma called us when she noticed a crack in her basement wall that was just slightly starting to leak water. Rather than wait to see if it would resolve on its own or just shrug it off as one of the idiosyncracies of a basement, she wanted it taken care of permanently.

We used FlexiSpan - a flexible sealant that is more effective than other sealants because it moves with the crack as walls shift and keeps it sealed - to fill the wall crack, ensuring that it won't leak or expand in the future.

Jamie W. noticed the area around the chimney in her basement was leaking and as time went on the water seepage increased. The basement had block wall foundation and was finished, so the homeowner wanted the problem resolved before the rest of the area became damaged by water intrusion.

We first installed WaterGuard, which is perimeter drainage system that collects intruding water through specialized pipes at the base of each wall and automatically drains it into the sump pump, rather than allowing the water to leak out onto the floor. We also included an inspection port for the WaterGuard system that gives us access to the drainage pipes if ever needed. A FloodRing was installed around the home’s water heater to ensure the basement was protected from a burst that could cause the space to flood. This system also included an alarm that warns the homeowner of a potential leak or burst in the water heater so the issue could be addressed before an actual flood occurred.

The final installation for this project was an additional discharge line that ensured water exiting the home from the sump pump had an efficient route outside of the home.

This homeowner called because he had a slab on his sidewalk that sunk a few inches. He was looking for an effective solution that would raise the slab and prevent future settlement.

We installed the PolyLevel system to raise and stabilize the sunken slab. Several small holes were drilled into the slab and filled with a specialized polymer material that addressed the weak soils below that caused the slab to sink, while ensuring the concrete stayed in place over time. Once the holes were injected, the polymers expanded to lift the slab back to its proper position. This installation had a short cure time of 15 minutes and caused minimal disruption to the home.

Sam M. of Saint Louis, MI was experiencing some difficult issues with his crawl space. For one the scrawl space had a sand bottom, and for two, water was getting into the crawl space and soaking the sand. The crawl space was becoming very humid and this humidity was traveling up into the home. This said, we had a solution.

We installed two of our patented products for this job: the CleanSpace crawl space encapsulation system and the SaniDry CX standing dehumidifier. CleanSpace is a 20mm thick plastic lining that completely seals off the crawl space from the surrounding elements. No ate, cold air, or moisture will be able to get past this lining. 

The SaniDry CX is a powerful dehumidifier that can remove up to 109 liters of water per day. This product will keep Sam's crawl space, and thus, his home, free of humidity. 

One of our customers from Perrinton cslled us about their basement, they wanted help waterproofing it so that it could handle all the curveballs that michigan's weather throws us each year. We installed our SuperSump which is perfect for getting the water out of the basement as efficiently as possible.

The SuperSump contains a pump stand (prevents clogging of any debris in the sump liner), pump alarm (for when the basement floods), and an airtight sump lid with a floor drain in it (helps water to go down but not air to come up).

We've all been in an old basement with concrete floors, right? Have you noticed how the floor looks as if it's deteriorating? Well, we know how to turn back time on your concrete slabs and make them BETTER than new. We can do this by installing our PolyLevel technology, as we did on this Riverdale home.

We came to this homeowners property and installed our PolyLevel in their basement, which is an advanced polymer-based injection foam. We blast this foam in through tiny holes that are just smaller than a dime. Once we do this the concrete is level and stronger than ever. PolyLevel worked to raise and level out the concrete slabs while dealing with the weak soils below that were no longer able to hold the weight of the home above. We drilled multiple small holes into the concrete slabs in order to inject them with a polymer material that expanded to lift and level out the concrete. Once injected, the system only needed about 15 minutes to fully cure and the slabs were then stabilized and lifted to their proper level, and stronger than ever before. Now, this homeowner will not have to worry about this ever again.