Total Crawl Space Repair & Concrete Leveling in Williamsburg, MI

Williamsburg, MI Wall Goes From Drywall to FlexiSpan

Tom of Williamsburg, MI was so eager to have a crack in his basement wall patched up that he removed the drywall for the crew before they arrived. To repair the actual crack, the crew used our FlexiSpan system. The FlexiSpan system works by using two different layers of a flexible sealant. After the first layer is placed into the crack to plug the leak, a second layer is then applied to span the wall and create a pathway for any excess water to drain. But first, the crew installed a drainage system at the foot of the wall, so that any leaking water would have somewhere to go. The waterproof seal will provide the wall with much-needed protection, and after snapping a BrightWall panel into place, the room is just a paint job away from its former beauty.

Multiple Cracks Get FlexiSpan Treatment In Williamsburg, MI

Jordan had a basement crack that had some water seepage as well as some water seepage from the area immediately below his sump pump discharge. With the water seepage confined to these 2 small areas, we were able to use FlexiSpan to solve the problem. The slab foundation was excavated immediately below the cracks and a dry well a few gallons deep was dug out. This is a space where the water will flow and work its way back into the the ground. The well is filled with stone and the concrete is replaced. A gap along the base of the wall remains open to allow the water seepage to flow into the well. Finally the cracks are covered with a foam layer followed by a layer of our mold and mildew resistant CleanSpace material. The foam creates a space for water to move freely down the wall and the CleanSpace material creates a vapor barrier and allow the water to flow without being seen or noticed, plus it looks great on the walls. Jordan's problem is solved.

Uneven Sidewalk in Williamsburg, MI

Don't let uneven sidewalks leave you feeling stressed out. With new technology we can fix those uneven sidewalks or cement slabs easier than ever before. We inject structural grade polymers beneath the cement which will lift the slab back to its desired height. The polymers are waterproof so you don't have to worry about them washing out, once injected they are there to stay. The hole we have to drill to inject the polymers is smaller than a penny and barely noticeable. The best part is this system only takes about 15 minutes to install so there is almost no down time and you'll be back driving on your driveway in no time.